螺桿泵正確的啟動步驟
Screw the right to start the steps
注意事項
Notes
1.G型螺桿泵開機前必先確定運轉方向，不得反轉。
1.G-type screw pump running pre-boot must first determine the direction, shall not be reversed.
2.G型螺桿泵嚴禁在無介質情況下空運轉，以免損壞定子。
2.G is strictly prohibited without the media-type screw pump under air operation, so as to avoid damage to the stator.
3.新安裝或停機數天后的G型單螺桿泵，不能立即起動，應先向G型單螺桿泵體內注入適量機油，再用管子鉗板動幾轉后才可起動。
3. The new installation or down a few days later G-type single-screw pump, can not immediately start, should first G-type single-screw pump body into the amount of oil, and then pipe clamp plate start moving only after a few trips.
4.輸送高粘度或含顆粒及腐蝕性的介質后，應用水或溶濟進行沖洗，防止阻塞，以免下次起動困難。
4. Transport of high viscosity or containing particles and corrosive media, the application of water or solvent to wash, to prevent the obstruction, so as to avoid difficulties in the next start.
5.冬季應排隊積液，防止凍裂。
5. In winter should be fluid line to prevent the Frost Crack.
6.G型螺桿泵使用過程中軸承箱內應定期加潤滑油，發現軸端有滲流時，要及時處理或調換油封。
6.G the process of using bearing-type screw pump should be regularly lubricating the box and found that when the shaft there is seepage, a timely processing or exchange seals.
7.在運行中如發生異常情況，應立即停車檢查原因，排除故障。
7. In the event of abnormal operation should immediately stop checking reasons, troubleshooting.
|
